Menu
Home
Log in / Register
 
Home arrow Engineering arrow Tactile Display for Virtual 3D Shape Rendering
Source

Modality with Interval Definition and Variable Distance Between Control Points

The third modality is similar to the second one but the selection of the centre point is made directly by the software. Indeed, the user has to select only the portion of the surface to render and the software selects the position of all the control points

Phase 3 - Servomotors positions

Fig. 6.20 Phase 3 - Servomotors positions

according to the boundary condition (collision avoiding and strip length). These points are placed, when possible, in sensible points, such as relative minimum point, relative maximum point and high values of curvature variation. Figure 6.17 shows two conceptual examples of the control points management for a generic trajectory in the modality with constant distance between control points.

Once the positions of the points are defined, it is possible to calculate the normal vectors to the surface. Figure 6.18 shows an example of the selection of a control point in a relative maximum point and the consequent normal vector.

Leaving the software free to choose all the control points positions, it is possible to obtain the best rendering. Indeed, by placing the control sectors in these points, it will be possible to set the system in the best configuration to control the strip deformation. Figure 6.19 shows the procedure used to manage the control points with the described modality.

Phase 3: Calculation of the Servomotors Positions and Sending of Serial Signals

The coordinates and the torsional and tangential angles of each control point are the output of Phase 2. These data are used as input for Phase 3. This step reads the coordinates and the angles of the control points. By means of the inverse kinematic analysis, it calculates the angular position that each servomotor has to assume in order to perform the rendering (Fig. 6.20).

Control process

Fig. 6.21 Control process

After that each angular position is converted from an angular value to the appropriate millisecond value according to the RC PWM communication protocol. Figure6.21 shows the whole control process.

 
Source
Found a mistake? Please highlight the word and press Shift + Enter  
< Prev   CONTENTS   Next >
 
Subjects
Accounting
Business & Finance
Communication
Computer Science
Economics
Education
Engineering
Environment
Geography
Health
History
Language & Literature
Law
Management
Marketing
Mathematics
Political science
Philosophy
Psychology
Religion
Sociology
Travel